Shrop Rock Doctor

Shrop Rock Doctor Diagnosis, repair & service of electronic music-production equipment & instruments.

This Accessit Stereo spring reverb was sent directly for service following an auction site purchase by the customer. The...
29/12/2023

This Accessit Stereo spring reverb was sent directly for service following an auction site purchase by the customer. The system comprises of 3 component parts interconnected with 5 pin din (midi) cables, all pins wired.
Pots cleaned, circuit boards & components inspected, some soldering reworked. Spring trays secured with foam blocks for shipping but will require removal by the customer upon receipt. Reverb tanks don't travel well by post 😔. One spring was disconnected when I received the units.
PSU plug top replaced & correctly wired & fused.

Fender Hotrod had intermittent reverb.Root cause was the poorly fitting phono plugs on the reverb tank. Someone's attemp...
29/12/2023

Fender Hotrod had intermittent reverb.
Root cause was the poorly fitting phono plugs on the reverb tank. Someone's attempt to secure them with wire wraps was unsuccessful so I replaced the plugs.

Straightened the chassis of the Mesa Boogie Lone Star following an unsuccessful journey with a courier service 😞.The cha...
29/12/2023

Straightened the chassis of the Mesa Boogie Lone Star following an unsuccessful journey with a courier service 😞.
The chassis is aluminium but fortunately had welded corners which probably prevented worse deformity when obviously dropped. The weight of the two large transformers shifted the chassis out of alignment with the the casing apertures.

Finally got around to replacing the electrolytic capacitors in the Sony STR6200F receiver.
29/12/2023

Finally got around to replacing the electrolytic capacitors in the Sony STR6200F receiver.

Pedalboard build.
22/12/2023

Pedalboard build.

Kit guitar brought in for assembly. Body & neck apparently purchased from China.This definitely wasn't intended for an i...
22/12/2023

Kit guitar brought in for assembly. Body & neck apparently purchased from China.
This definitely wasn't intended for an inexperienced builder. Neck requires gluing in & the heel and pocket are not machined correctly. The neck required tilting back considerably to get anywhere near a playable action.
The bridge posts require drilling in in the correct position. Using my jig I am able to string up & move the bridge around to achieve correct scale length, intonation and string /neck alignment before committing to drilling in the posts. What this also highlights is the fact that the pickup pockets are out of position because to achieve good string/pole piece alignment the pickup requires pushing hard against one end of the pocket. It isn't possible to remove anymore material for increased clearance because the pickup ring will not cover the pocket end.
Definitely not one for the beginner.

Marshall AS50R combo fitted with a replacement reverb tank. Original had an open circuit transducer. ...
22/12/2023

Marshall AS50R combo fitted with a replacement reverb tank. Original had an open circuit transducer.

These three came in for a service this week. &Ltelecastee
22/12/2023

These three came in for a service this week.


&Ltelecastee

Alesis RA150 power amplifier repair following a shorted output to its own input 🙄😔.Amazingly it only opened a single res...
22/12/2023

Alesis RA150 power amplifier repair following a shorted output to its own input 🙄😔.
Amazingly it only opened a single resistor which when replaced totally restored proper operation. Removal of the channel amplifier module was required but fortunately didn't require removal of the board.

Peavey Mini Mega 1000W bass head.Brought in blowing rear panel fuse.No visible damage but startup on current limiter sho...
22/12/2023

Peavey Mini Mega 1000W bass head.
Brought in blowing rear panel fuse.
No visible damage but startup on current limiter shows definite high current draw immediately it reaches 110vac input.
Removal of the power supply / amplifier board revealed a screw floating around below the board. Second image shows the offending screw & it can be seen on the top right of the front panel pcb where it came from. It has obviously shorted something.
Owner says the amp has never been opened since its purchase as a new amp so possibly not correctly tightened at manufacture.

Fender Hotrod Deluxe iii in for attention to non functioning reverb.
22/12/2023

Fender Hotrod Deluxe iii in for attention to non functioning reverb.

Mesa Lone Star head in for attention to a bent chassis, the result of shipping damage 😔.
22/12/2023

Mesa Lone Star head in for attention to a bent chassis, the result of shipping damage 😔.

Address

95 Lodge Lane
Bridgnorth
WV155DF

Opening Hours

Monday 9am - 6:30pm
Tuesday 9am - 6:30pm
Wednesday 9am - 6:30pm
Thursday 9am - 6:30pm
Friday 9am - 6:30pm
Saturday 9am - 6:30pm

Telephone

+447312878416

Website

Alerts

Be the first to know and let us send you an email when Shrop Rock Doctor posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Practice

Send a message to Shrop Rock Doctor:

Shortcuts

Share

Share on Facebook Share on Twitter Share on LinkedIn
Share on Pinterest Share on Reddit Share via Email
Share on WhatsApp Share on Instagram Share on Telegram