Kinugawa Turbo Systems

Kinugawa Turbo Systems Just less than 3 steps! Easily customize DROP-IN or BOLT-ON turbocharged solutions, helping enthusiasts boost creativity and horizons.

Kinugawa Turbo Systems helps people boosting their "creativities" into the powertrain such as Subaru, Mitsubishi, Toyota, Nissan, VOLVO, SAAB, VW, FCA with wide-range horsepower.

🚨 White smoke after a fresh turbo install? It's probably not the turbo.We tore down a CT26 60-1 from a Toyota MR2 3S-GTE...
02/04/2026

🚨 White smoke after a fresh turbo install? It's probably not the turbo.

We tore down a CT26 60-1 from a Toyota MR2 3S-GTE and found the real cause — oil starvation. The shaft ran dry at 100,000+ RPM, cooked the seal from the inside, and the smoke came after.

Before fitting a replacement, check: ✅ Oil pressure at the turbo feed port ✅ Oil feed line — replace it, don't reuse it ✅ Oil drain line — must flow freely downward ✅ Prime the turbo before first start

Same turbo + same oil system = same failure in minutes.

Full teardown with photos 👇 🔗 https://store.kinugawaturbosystems.com/blogs/troubleshooting/white-smoke-after-turbo-install

🔴 Brand new turbo. 1,500 km. Completely destroyed.No abuse. No aggressive tune. No foreign objects.Just a clogged air fi...
01/04/2026

🔴 Brand new turbo. 1,500 km. Completely destroyed.

No abuse. No aggressive tune. No foreign objects.

Just a clogged air filter creating enough vacuum to pull the rotor forward at high RPM — until the blades ground themselves into dust against the housing wall.

Half a liter of oil in the intercooler. Aluminum slurry throughout the charge system. Uniform blade wear across every single blade.

This is what extreme axial displacement looks like. And most people never see it coming.

Check your air filter. Inspect your intake piping. Don't let a $20 filter destroy a $1,000 turbo.

🔗 Full teardown + case study → https://store.kinugawaturbosystems.com/blogs/troubleshooting/turbo-axial-play-causes-diagnosis-fix

💬 Seen this before? Tell us below.

2024 WRX TR is back for more 🤟🏻Mod list is as follows: Intake/J pipe VB flex fuel kit/AP v3DW low side fuel pump Mis...
24/03/2026

2024 WRX TR is back for more 🤟🏻

Mod list is as follows:

Intake/J pipe
VB flex fuel kit/AP v3
DW low side fuel pump
Mishimoto Automotive FMIC kit
TD06-71 turbo
All else stock

Graph shows 93RON/E59

450whp/425tq 18psi E59
390whp/385tq 16psi 93RON

We will be turning the car up very soon after some driveline upgrades.

Thanks for reading!

Tuning services for purchase on the website

www.reesetuning.com

A couple mockups of new & refreshed parts.For the 19T turbos I went with a dark bronze powder coat on cold side, funk...
25/02/2026

A couple mockups of new & refreshed parts.

For the 19T turbos I went with a dark bronze powder coat on cold side, funk Motorsport heat blanket on hot side, black cerakote downpipe with gold titanium studs.

I matched the red on the rear valve cover to the front. Originally I had a black DIY paint job on the rear.

Pretty much all visible brackets will be either black or metallic silver.

I finished camshaft seals and the big bore lifters yesterday. I’ll start slowly reassembling everything on the engine in the coming weeks.

I still need to finish the transmission and transfer case refresh & new seals. Then I am going to tackle the engine bay. Tons of new parts to install all around.

twinturbo

Mint day at Swan Gulley 4x4 Park had heaps of laughs🤣🤣 and to top it off we supported Autism Queensland while doing it ...
08/02/2026

Mint day at Swan Gulley 4x4 Park had heaps of laughs🤣🤣 and to top it off we supported Autism Queensland while doing it by chipping in and joining SS4x4’s convoy out to the park🤙👊

03/02/2026

.straya Abit of a run up does the trick😁

02/02/2026

Новая турбина . Осовременил дизелек , осталось настроить топливо и доработать впуск (мало свиста, хочу слышать ВСЁ). Но уже сейчас едет как атмосферный объемный двигатель, турбояма пропала.

New modern ball bearing turbo on old diesel. Still requires some fuel tune, but even now it goes much better then it was. Turbo lag doesn’t exist anymore 👍

01/02/2026

Unpacking my new TD04HL-19T turbos. Now to get them disassembled for powder coating. Going with a Bronze cold side and a Funk turbo blanket for hot side 🤔

twinturbo

.performance First tune of the year. Chris’s jzx100, running a kinugawa bolt on turbo with turbosmart external wastegate...
21/01/2026

.performance First tune of the year. Chris’s jzx100, running a kinugawa bolt on turbo with turbosmart external wastegate, Tomei poncams, sard fuel rail with 1000cc injectors, apexi power fc and avcr making some solid and responsive power for a stock bottom end 1jz.

Address

Nantouhsien
54260

Telephone

+886492315117

Website

Alerts

Be the first to know and let us send you an email when Kinugawa Turbo Systems posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Practice

Send a message to Kinugawa Turbo Systems:

Shortcuts

Share

Share on Facebook Share on Twitter Share on LinkedIn
Share on Pinterest Share on Reddit Share via Email
Share on WhatsApp Share on Instagram Share on Telegram